Drive Sprockets
Auger Drive Sprockets
3.067″ PITCH: BARE DIGGING CHAIN & DIGGING CHAIN ASSEMBLIES
3.067″ CUP TOOTH CHAIN 6″ CUT
Low-cost trencher chain
Best for trenching sand, sandy loam, loose shale, loose soil, caliche and clay.
3.067″ 50/50 COMBO CHAIN 6″ CUT
(CARBIDE TIPPED BULLET BITS & CUP TOOTH)
This 50/50 chain configuration allows for trenching in almost any type of ground. The carbide tipped replaceable bullet bits are bolted to the chain and used to break up the ground. The cup teeth follow to clean the trench. Use on loose dirt, medium and hard rocky soil.
3.067″ PITCH 50/50 COMBO CHAIN 6″ CUT
(CARBIDE TIPPED SHARK TEETH & CUP TOOTH)
This 50/50 chain configuration allows for trenching in almost any type of ground. The non-replaceable shark tooth will outlast the chain. The cup teeth follow the shark tooth to clean the trench. Use on loose dirt, medium and hard rocky soil.
3.067″ SHARK TOOTH WELDED CHAIN 6″ CUT
The welded shark tooth chain is a maintenance free low profile chain assembly. The carbide tipped shark tooth will outlast the chain. Tension adjustment is the only maintenance required. A great chain for digging hard rock, caliche, coral, and limestone.
3.067″ ALL ROCK & FROST CHAIN 6″ CUT
(CARBIDE TIPPED BULLET BITS)
The bolt-on rock and frost chain are used on hard rocky conditions and frozen ground. This chain uses replaceable carbide tipped bullet bits to pick and fracture hard rock and frozen ground.
3.067″ ALL BULLET H-PLATE CHAIN 6″ CUT
Do you need a chain for trenching in extreme conditions? Use this chain in hard rocky conditions, frozen ground, asphalt and concrete. The welded h-plate chain gives you the best bit penetration angle plus great trench clean out. This assembly has heavy-duty, heat-treated pockets and rock bits with pocket protectors.