Cup Cutters
Carbide Cutters (Bullet Bit Type)
Carbide Cutters (Shark Tooth Type)
Drive Sprockets
End Roller
End & Idler Sprocket
Double Standard Chain
Standard Chain
1.654″ PITCH BARE DIGGING CHAIN & DIGGING CHAIN ASSEMBLIES
(Pitch is the center-to-center measurement of the chain pins)
(Number of links on a chain is the number of chain pins divided by 2)
STANDARD CHAIN – 1.654″ PITCH CUP TOOTH CHAIN 4″ CUT
LOWEST-COST STANDARD TRENCHER CHAIN.
Use in the easiest of digging conditions such as sand, sandy loam, loose shale, loose soil, and sticky clay.
1.654″ DOUBLE STANDARD PITCH BARE CHAIN
1.654″ PITCH DOUBLE STANDARD CUP TOOTH CHAIN 4″ CUT
LOW-COST DOUBLE STANDARD TRECHER CHAIN.
Best for trenching sand, sandy loam, loose shale, loose soil, caliche, and clay.
1.654″ PITCH 50/50 COMBO CHAIN 4″ CUT
This 50/50 double standard chain configuration allows for trenching in almost any type of ground. The carbide tipped replaceable bullet bits are bolted to the chain and used to break up the ground. The cup teeth follow to clean the trench. Highest productivity on loose dirt, medium, and hard rocky soil.
1.654″ PITCH 50/50 COMBO SHARK CHAIN 4″CUT
This 50/50 chain configuration allows for trenching in almost any type of ground. The non-replaceable shark tooth will outlast the chain. The cup teeth follow the shark teeth to clean the trench. Highest production on loose dirt, medium, and hard rocky soil.
1.654″ PITCH WELDED LOW PROFILE SHARK CHAIN 4″ CUT
The welded shark tooth chain is a maintenance free low-profile chain. The carbide tipped shark tooth outlast the chain. Tension adjustment is the only maintenance required. High productivity on hard rock, caliche, coral, and limestone. Good for tree roots.
1.654″ PITCH ALL BOLT-ON BULLET BIT CHAIN 4″ CUT
The bolt on rock and frost chain are used on hard rocky condition and frozen ground. This chain uses replaceable carbide tipped Bullet bit to pick and fracture hard rock and frozen ground. More aggresive chain.